WTB - 27" Cat Hull

[Rocstar]

Looking for a 27" cat hull or slightly smaller, preferably undrilled.

[Hor2012]

I have a king of shaves hull. Needs some loving lol

[Rocstar]

Thanks, but looking for 27" or less.

[ray schrauwen]

Randy Naylor of BBY has a nice one prebuilt with paint I think. Just add electronics!

Give him a shout. He offered it to me but, I'm not in the market for one right now.

[siberianhusky]

I have a H&M drifter S I might sell, be hull and hardware less electronics.
Sponsons have been filled and leveled, was getting close to the 60mph mark with a UL-1 motor and esc. Short SAW runs of course.
Etti motor mount, chinese carbon fibre(?) servo mount, Inline strut and rudder, If I remember right I used a Hughey flex cable, no teflon liner setup, runs in straight brass.
Was contemplating a 4200kv Lehner this year and see what it'll do on 2s.
Stays dry inside.
Give me a PM if interested, I'll take some pictures.

[Alexgar]

i have this one but its quite smaller than the 27" your looking for only 21" but havent done a thing to it since my last post in the build . PM if interested

[Sheldon03]

Hor212; are you looking to sell the KOS hull? PM me

[RandyatBBY]

I do build a 26 inch boat the Scat Cat 26. In fiberglass link. FYI
http://www.bbyracing.com/electunnelsandcats.asp

[Basstronics]

Hey,

I was at the Toledo R/C show today and TFL has the 27" fightercat Lynx in CARBON FIBER for $150 out the door. I guess they make most if not all of the hulls for Fightercat, even the hardware (there was CF motor mount on table FS).

TP Power is also there giving out some rocking deals!

[ray schrauwen]

Dang...

[Basstronics]

Also had a CF Rivercat & Genesis- both more expensive than Fightercat. Also a Cheetah- for $200! :(

[Rocstar]

Thanks guys. I ended up finding 2 hulls. FCR Lynx and a H&M Drifter S.

[rplebuch]

26" blackjack reinforced middle already drilled awaiting motor and esc
Make an offer
97484974859748697487