FS- Revolt RTR, Blackjack 29 Never Wet RTR

[sturco]

FS- Selling off 2 RTR's to fund a new Cheetah build. Please see below:
1. New RTR Blackjack 29, never wet. Wood epoxied, velcro added, shaft lubed. All new as delivered. Original box etc. No chips, marks etc. $385.00 delivered to lower 48

2. Revolt RTR, run 6 times. Tactic 2.4 TTX240. OSE upgraded shaft, collet & thrust brg. Balanced & sharpened Grim 42X55. Epoxied wood, no marks, cracks etc. (1) corner chip 1/4" on cowl corner edge (dropped cowl). declas removed, model pin stripe added,(removable). Looks better. $285.00 delivered to lower 48.

Both have original boxes, manuals etc. Will ship everything that factory supplied. Questions, please e-mail me
Steve, sturco1@twcny.rr.com8844688447884488844988450

[sturco]

Photo for Revolt interior can be e-mailed. Won't fit in original post.

[lenny]

So put them in post.,#2
Five per post.

[sturco]

88459

[darrin4800]

How much for the blackjack minus t/x and r/x?

[worriedsick4u]

I'll give you $250.00 for the Revolt.

[sturco]

Guys,
1. Prefer to sell BJ as RTR
2. $275.00 Revolt

Thanks, Steve

[worriedsick4u]

Money sent for Revolt. Please confirm receipt. Thanks

[sturco]

Got it, Thank you ! I'll get it all pkg'd up & shipped tomorrow ASAP. I'll also get you the tracker.
Thanks, Steve

[mtbenjamin77]

I interested in the BJ29 RTR. The wood has been epoxied? can you explain the process of how you epoxied the wood?

[sturco]

mtbenjamine77, I mixed up some 30 minute epoxy and brushed a thin coat on all the wood/glass joints. Also applied to the surfaces of the wood. Only removed the velcro'd RX,ESC & lipo/nimh switch to get better coverage. Basically followed the suggestions from members who do this for added strength & harmonmics reduction. Any other questions, feel free to contact me. Steve

[mtbenjamin77]

mtbenjamine77, I mixed up some 30 minute epoxy and brushed a thin coat on all the wood/glass joints. Also applied to the surfaces of the wood. Only removed the velcro'd RX,ESC & lipo/nimh switch to get better coverage. Basically followed the suggestions from members who do this for added strength & harmonmics reduction. Any other questions, feel free to contact me. Steve

what type of 30min? I know my 30 min does not brush on very well, its too thick. Shoulda prolly used 24hr finishing resin. Did any get on the inside of the hull? I'll prolly pick this up from you but I to make sure that I can still easily remove the wooden framing.

[sturco]

I used Bob Smith Ind slow (?) 30 minute epoxy. The only parts of the inside of the hull that were epoxied were the joints that meet the wooden parts. You are right, the tops of the wood pcs. were thicker than the "seam" portions. Mostly the tops of the battery trays and ESC, steering servo wooden tray. It's not glass finished but noticable. I'll work with you on this $, let me know your thoughts ?
Steve

[sturco]

BTT, New Price $350.00 shipped

[dre414]

PM Sent on the Blackjack.. still have it for sale?

[dre414]

Payment sent for the Blackjack.. please confirm, thanks!

[sturco]

All Set ! Will ship today & get tracker for you also. Thanks, Steve