gtrcguru
10-06-2012, 11:18 AM
just got back from running and when i pulled my boat out the water the flute tips on my cnc prop were broke off.
i know i did not hit any thing, the prop is not bent and i coud not tell it was broke while i was running.
i checked the prop with a micrometer and both breaks are within .0005".
any one else have this problem?
i know i did not hit any thing, the prop is not bent and i coud not tell it was broke while i was running.
i checked the prop with a micrometer and both breaks are within .0005".
any one else have this problem?