T180- needs cleaned up

[Basstronics]

I bought this used. It does work, bench tested 4S on a Leo 4074

It does need cleaned up and some work. Needs 10Ga power wires replaced. Comes with 5.5 bullets all around, Sbec and 3 extra caps that were part of this.

I dont have the time to mess with this. I started to clean it up, CorrosionX applied. Just going a different route and want my $$ back.

$57 shipped in the USA. and sold as is especially since you have to solder new wires on.

http://i38.photobucket.com/albums/e136/basstronics/For%20Sale/100_7751.jpg
http://i38.photobucket.com/albums/e136/basstronics/For%20Sale/100_7750.jpg

[masonis1]

Might be interested

Sent from my SPH-D700 using Tapatalk 2

[Basstronics]

To clarify:

This ESC will need new 10Ga power leads replaced or you could reshrink it. But to be safe I advise new wire.

While doing this the SBEC needs to be soldered into the + and - terminals to permanently attach. If you want to reuse the caps then attach those as well.

It was my intent to clean this ESC up and use it. However I dont have time to mess with it.

[HYDROJERRY]

I will offer 35.00 shipped to 27549,, wright now, but it must work wright,, no posibly's!!!

[Basstronics]

Sold!