Traxxas 380 - 4000kv Motor, MINI/MICRO hardeware / PROPS & MORE

[monojeff]

Here is the list of stuff I have and prices everything is OBO buyer pays actual shipping cost of your choice.
Willing to sell as a lot or discount for multiple items.

Traxxas 380 4000kv motor with cooling jacket - $30
2040 - 4200kv Motor not sure of the brand - $5

2.2mm to .098 coupler - $10
Not sure on the actual size but fits a 550 brushed shaft to .098 coupler - $5

1/8" Plastic & Carbon props: $7
qty 2 carbon 30mm
qty 3 x431
qty 1 y531
qty 2 y534
A few were lighlty used but basically all still in NEW condition

Octura x427 - $7

Mini Servos: -$10
qty 1 Turnigy TG9
qty 2 Ace Metal Gear C1016 specs found here: http://www.servodatabase.com/servo/ace-rc/c1016

New never used Micro Rudder & Strut - $15

Qty 3 .098 flex shaft 1/8" stub shafts with teflon liners - $15
1 measure 8" and has stub shaft and bullet nut (Measurement to end of stub shaft)
1 measures 9" and has stub shaft, drive dog and bullet nut (Measurement to end of stub shaft)
Other is just the flex and measures 9 1/4"
18" of teflon liner

Suppo 200amp ESC with 3 bullets and dean connectors for battery- External BEC - $15
Also have xtra bullets and wires which will include with the ESC

[lenny]

Jeff,:tiphat:
I will take the suppo if it works ok.
Also looking for some part that will fit a mini bolt,
But not sure if what you have will work.

Thank for any info on the stuff.

[monojeff]

Everything is in working order the ESC runs great.

What size is the mini bolt?
You can look on the OSE site for details on the micro rudder and strut what boats they work good for.
Not sure what else you need? :noidea:

[monojeff]

Motors
Servos
Drive lines
Props are all pending payment.

[lenny]

Ok jeff,
Just the esc is left ?
If so send me your paypal,
And total with shipping to NJ 08062.

[monojeff]

The coupler, rudder and strut are still available.

I will pm you with details.

[Basstronics]

Is that a coupler I made?

If so its 2.2mm (what the 2040 small bolt motor is) and .098" cable. I know there was some debate about 2.2 vs 2.3 (.087" vs .091") I measured mine with quality devices (micrometer) and went with the drill thats going to give me best size. Not the actual size which blows over ;)

[lenny]

What coupler is left ?
I have the etti coupler, But it wobble. :glare:
And I got 2.32mm motor shaft and 0.95 flex shaft.

[monojeff]

Hey bass yes it's one of your couplers.
Very nice piece it's new and never been used.
The 2 couplers in the photo which are listed at the top of the page.

[lenny]

How long is the one bass made ?

[monojeff]

How long is the one bass made ?

7/8"

[lenny]

I think it will work, The one I have is 1 1/16.
Add it to my bill please.

[lenny]

Paypal sent,
With my info Jeff.

Thanks.:beerchug:

[monojeff]

Everything sold and shipped.

Thanks guys enjoy.