BakedMopar
12-03-2011, 11:37 PM
I have a problem with my charger. I was charging two 6s 5000 at 1c and around the 90% mark both channels read connection error. I have had these problems before that a little jiggle on the balance board and it would be okay, but when I tried to stop it, both screens went blank (still backlit) and started beeping. Even unpowered and repowered with no luck, blank screen and beeping. When I connect it to the computer it says that port two have a reverse polarity error. Even by pressing Stop on the computer and can't get it to stop. I don't know why it went into reverse polarity as it wasn't and the battery is fine.
Does Hyperion have any warranty? I tried emailing allerc as thats where I got it. Anybody had this happen or any clue on how to reset it if its possible? I'm guessing its dead :confused2:
Does Hyperion have any warranty? I tried emailing allerc as thats where I got it. Anybody had this happen or any clue on how to reset it if its possible? I'm guessing its dead :confused2: