PDA

View Full Version : 15% Off at Minicat Racing USA


sailr
11-20-2011, 07:02 PM
Just in time for Christmas, we are offering 15% off of all purchases over $100 until Dec. 31st. This is for OSE members only! To qualify, you must send me a PM with your real name and address to verify your OSE membership. Then make your purchase as usual from our website and we will rebate the 15% to your paypal account. PM me for any questions.
Thanks. Happy Thanksgiving everyone!

Jim
nmnorth
11-23-2011, 08:17 AM
hi jim, i believe i have a boat you used to own , an aeromarine preditor fe tunnel with a hacker motor. i need your help, the turning bar broke, where did you get that motor mount for the k&b lower unit?? if you could please email me at nmnorth@aol.com or call me 440-449-3971 ,thanks Jim, Bill
sailr
11-23-2011, 05:15 PM
I'm not sure which adapter you have on there. I sold it without a motor. Is it black plastic or aluminum?
nmnorth
11-23-2011, 06:52 PM
its, a plastic mount, Bill
Alexgar
11-23-2011, 07:24 PM
Jim what that break down to on a mini mono with the discount shipped or a hydro been thinking about a mini to run beside my velocity
Alexgar
11-23-2011, 07:28 PM
Also wondering if I could get on minus the esc but with a bigger tenshock 4 pole
nmnorth
11-23-2011, 07:45 PM
jim, its a plastic mount, Bill
sailr
11-23-2011, 09:35 PM
Take 15% off the price of the boat and add $15 shipping (in the USA).


Jim what that break down to on a mini mono with the discount shipped or a hydro been thinking about a mini to run beside my velocity
sailr
11-23-2011, 09:36 PM
Sorry, we don't break the boats down. We don't have other motors for them. The new GII Viper 4 pole is about max for the boat anyway. You're looking at a 40-45mph boat!


Also wondering if I could get on minus the esc but with a bigger tenshock 4 pole
sailr
11-23-2011, 09:37 PM
jim, its a plastic mount, Bill

You can get it here. Partway down the page. $15

http://www.drcwebservices.com/ffe/_private/hardware.htm
nmnorth
11-24-2011, 05:49 AM
thanks for that link, Jim, do you know also where i can get the screws to hold all that together,its for a k&b lower and i'm not sure of yhe sizes? are they metric or in? Bill
sailr
11-24-2011, 09:45 AM
Just take a couple of existing screws to ACE hardware and compare. I'm pretty sure they are NOT metric. Probably 6-32. The screws to hold the motor to the mount will be 3mm though. Be careful they are not too long or they will get into the windings and destroy the motor. Good luck.


thanks for that link, Jim, do you know also where i can get the screws to hold all that together,its for a k&b lower and i'm not sure of yhe sizes? are they metric or in? Bill