One of my current projects

[JimClark]

Here are a few pictures on one of my current projects

http://JimClark.smugmug.com/gallery/4309697_eh7Sy/1/267859224_FTJJL

Watch out Darin she will be running in Puget Sound Fast Electrics in Late may or early June along with her bigger sister (1/10th scale 67 Bardahl). Next step is skinning her

Jim

[SJFE]

Looks like its coming together nice. I noticed the jig your using. Clever stuff man. Thanks for sharing :smile:

[longballlumber]

Thanks for sharing Jim,

Whos kit is that?


Here are a few pictures on one of my current projects

http://JimClark.smugmug.com/gallery/4309697_eh7Sy/1/267859224_FTJJL

Watch out Darin she will be running in Puget Sound Fast Electrics in Late may or early June along with her bigger sister (1/10th scale 67 Bardahl). Next step is skinning her

Jim

[JimClark]

Doug Campbells new Karelsen from Gary Finlay's plans

[longballlumber]

I was just looking at this morning. On Doug's site it said we can get one from OSE, but I can't find it on Steve's site. If you don't mind me asking where did you get it, and what are you going to power it with?


Doug Campbells new Karelsen from Gary Finlay's plans

[JimClark]

It is a prototype kit that I am helping Doug with. Well to start off with for the 1/16th scale racing I was going to do I was going to use a Ammo 28-45-3600 motor and 2s 2500 or 3300 mah Lipos. I have tested a similar boat and this combo ran at in the high 30's if not 40mph with a x430r prop and came back only luke warm after 15 laps.

If I run in N2 I am just trying to figure that out.
Jim

[Flying Scotsman]

Jim, your photo skills are well known. we now have to add building skills.

Douggie

[Stealth Assassin]

What Is the jig covered with? :spy:

[JimClark]

Wax paper and the press and seal wrap for foods.

Jim