Waterproof pushrod seal.

[Boaterguy]

I didn't have very much footprint next to the strut on this hydro + I didn't have a pushrod boot on me, I would have to order one, so I made up this little contraption. two brass tubes with a piece of silicone joining them, the tubes get sealed with pieces of shrink wrap, and the whole unit gets filled with white lithium grease, completely waterproof.

[carlcisneros]

believe it or not, that is old scholl and used to work GREAT!!

I used to do that in the 80's when I started boating.

[Boaterguy]

ha, didn't know it was proven before.
carbon pushrod because the CG is too far back :)