Racer944
08-08-2011, 09:18 AM
Hi Guys;
I am relatively new to boats and to the Impulse 31 so have a newbie question...
To remove the shaft to grease, do I simply remove the set screws on the motor collet, and then remove the two bolts that hold the propellor strut to its bracket and then slide the shaft out with the strut as an entire assembly? The manual seems to indicate this, but I think the pictures are not quite right so just wanted to double check...
Also if you do this, I assume you guys are marking your struts somehow to be able to put them back properly adjusted? Seems like a pain to have to undo the strut each time and possibly loose your adjustments...
Thanks for the confirmation or info on this procedure...
Cheers;
Eric
I am relatively new to boats and to the Impulse 31 so have a newbie question...
To remove the shaft to grease, do I simply remove the set screws on the motor collet, and then remove the two bolts that hold the propellor strut to its bracket and then slide the shaft out with the strut as an entire assembly? The manual seems to indicate this, but I think the pictures are not quite right so just wanted to double check...
Also if you do this, I assume you guys are marking your struts somehow to be able to put them back properly adjusted? Seems like a pain to have to undo the strut each time and possibly loose your adjustments...
Thanks for the confirmation or info on this procedure...
Cheers;
Eric