PDA

View Full Version : Pete's Nitro Hunter 2



peells
02-23-2008, 08:40 PM
Hi Guys,
All is well here in Redding CA (Raining Cats and dogs) so it was a great day for boat building and I got her all skinned and the hatch support edges installed and the inside edges all faced with 1/64' birch plywood and the stripping which holds the lid in place is birch as well, I have to stop as I need to go to Home Depot and get some cabinet z clips to hook the front of the lid under the front edge of the hull. Enjoy the pictures, And a Hi to Mark and his brother Ryan at All Around RC:welcome:

Darin Jordan
02-23-2008, 08:58 PM
Pete,

Looking good... Is this a scratch build design? What are the dimensions??

peells
02-24-2008, 11:01 AM
Hey Darin,
the Dimensions are as follows length 28.5 inches beam 8.5 inches, and yes it is a scratch build, I designed the plans my self using AUTO CAD in my spar time. I have two variations of this boat and am working on a third to use jet power (not to be confused with turbine).

Avanti
02-24-2008, 04:56 PM
Looking good Peter