First run for modded spartan today.

[bdp1174]

Well I finally hit the water with my spartan after the Seaking 180 and tacon 3674 install.Thanks again Kevin:thumbup1:.
First run w/ batts in the middle on the smooth glass lake pulled full throttle hit a wake and barrel rolled popping the hatch off even though had some hatch tape on the canopy.But landed right side up and drove back to shore.The hard impact on the right side of boat popped the glue on the seam about three or for inches from the right rear going forward (along the glue seam).I reglued and took her back out for round 2.
This time batts all the way forward just to make sure.:Sinking:

Here is the video of that
:thumbup1:
Succesful day after a minor barrel roll at top speed.....:buttrock:
http://www.youtube.com/watch?v=2j604Tp5WSQ

[davey]

whats your speeds

[mtnbiker94]

Looks like yours was handling nice, I think i have my trim tabs set down way to far because way to much of the front of the boat is in the water even when i scoot the batteries back.

How do you like it with the new esc and motor combo? Did it all bolt right up??

[dag-nabit]

Lookin' good :thumbup1:

Running nice and stable with the batteries forward.

Kevin

[bdp1174]

Not sure on the speeds I need a small gps to put in it any recommendations?
I flipped it on my first run so was a little easier on it the second run but she was running strong.