bdp1174
06-15-2011, 08:54 PM
Well I finally hit the water with my spartan after the Seaking 180 and tacon 3674 install.Thanks again Kevin:thumbup1:.
First run w/ batts in the middle on the smooth glass lake pulled full throttle hit a wake and barrel rolled popping the hatch off even though had some hatch tape on the canopy.But landed right side up and drove back to shore.The hard impact on the right side of boat popped the glue on the seam about three or for inches from the right rear going forward (along the glue seam).I reglued and took her back out for round 2.
This time batts all the way forward just to make sure.:Sinking:
Here is the video of that
:thumbup1:
Succesful day after a minor barrel roll at top speed.....:buttrock:
http://www.youtube.com/watch?v=2j604Tp5WSQ
First run w/ batts in the middle on the smooth glass lake pulled full throttle hit a wake and barrel rolled popping the hatch off even though had some hatch tape on the canopy.But landed right side up and drove back to shore.The hard impact on the right side of boat popped the glue on the seam about three or for inches from the right rear going forward (along the glue seam).I reglued and took her back out for round 2.
This time batts all the way forward just to make sure.:Sinking:
Here is the video of that
:thumbup1:
Succesful day after a minor barrel roll at top speed.....:buttrock:
http://www.youtube.com/watch?v=2j604Tp5WSQ