PDA

View Full Version : hobbywing 150a programing



bbosncali
03-27-2011, 07:17 PM
Ok so I've just about every upgrade possible for my boat and the funny thing is my mg won't be here till tomorrow. I have a 150a hobbywing esc kinetic offset rudder x642 prop 4074 leopard 2 2s 40c 5000mah lipos and some kinetic hatch locks which have noting to do with performance. I have a turnigy esc programer but I'm unsure if I want toset the cut off mode to soft or hard and voltage protect to low med or high? I set the motor to normal lipos to 14.8vlt no brake 15deg timing 13hz and I think that's it. Any help would be apreciated

Shaun78
03-27-2011, 07:32 PM
100 degrees top dead center.

bbosncali
03-27-2011, 07:42 PM
:sarcasm1:What do you know??? You drive a brushless milk jug. Aka (spartan) lol

ron1950
03-27-2011, 07:55 PM
with a 150 a esc u could go to a bigger prop like a m445 and raise the strut ..... may have to trim the rear of the strut brace for the m445 though

bbosncali
03-27-2011, 07:58 PM
I have a prather 220 is that to much prop?

ron1950
03-27-2011, 09:13 PM
not at all