PDA

View Full Version : Any one ever converted a seagad to brushless?



brian6989
03-15-2011, 04:05 PM
I was wondering if any one knows of anyone that has converted a gas venom seagad to a brushless li po set up?

mappo
03-15-2011, 04:13 PM
I was wondering if any one knows of anyone that has converted a gas venom seagad to a brushless li po set up?

Chris, at Fine design have done a couple of boats, so you may want to contact him.

http://www.finedesignrc.com/deals.asp#Aero_Marine_45_XXX_mono

scroll down to the middle of page.

brian6989
03-15-2011, 04:21 PM
awesome thanks for the info

DyrtyByrd
03-15-2011, 07:35 PM
i was also considering buying a gkos hull and doing the same keep us posted if you decide to move foward with this

brian6989
03-16-2011, 12:18 PM
will do ....Thanks

Doby
03-16-2011, 12:42 PM
Better yet...keep us posted if you buy one from him and IF you actually get it.....his reputation for questionable dealings is legendary...proceed with caution.

brian6989
03-16-2011, 12:47 PM
I actully have a seagad already so I pry will try to figure out a good set up I really like the hull and design of the boat hull but have had nothing but problems every time I have taken it out not to mention my girl friend almost cutting foot off because the prop starts spinning the minute you fire it up.

DyrtyByrd
03-16-2011, 01:07 PM
i have been playing around with some numbers and was thinking of
leopard 5892 1000kv
castle 240hv
10s lipos
not sure about the prop yet but should be a very hot setup
or for a more reserved setup
leopard 5892 1090kv
castle 240hv
8s lipos
or go twin
leopard 4082 2200kv x2
t180 x2
4s x2
obviously this option would cost more

brian6989
03-16-2011, 01:43 PM
wow thank you for the info that set up would really wake that boat up

DyrtyByrd
03-16-2011, 08:03 PM
no problem im new myself but im getting the hang of picking out setups

Brushless55
03-30-2011, 08:14 PM
twins would be very cool!