Neu 1521 1.5d f/s

[jpracing1997]

I have a Neu 1521 1.5d for sale with 5.5 connectors and 8mm shaft. Willing to trade for a 1527 1d or make me some offers. $200 shipped

[mpg43]

how old is the motor?

[jpracing1997]

The date is 08. I'll have to check on the day and month. It's outside in my shop right now. I got it from the original owner and he never ran it. So I am the first to run it and I ran it on 4s and only ran it 4 passes yesterday.

[mpg43]

Thats ok , I was looking for the newer version.

[jpracing1997]

??????

[HOTWATER]

I believe on the newer versions of the Neu motors, you are not required to run a thrust bearing on the can like the ones that were produced earlier (not sure on the dateline changeover)....therefore the shaft does not need to be cut either.... (I know the 15 series motors are this way now)

-Kent

[jpracing1997]

I know the shaft hasn't been cut on this one and not sure about the bearings?
Might be sold pending payment from 6s hydro.Thanks and I'll let ya know if it doesn't sell.

[HOTWATER]

Nice! 6S probably knows those motors better than I do...

Good luck with the sale!

[mpg43]

I believe on the newer versions of the Neu motors, you are not required to run a thrust bearing on the can like the ones that were produced earlier (not sure on the dateline changeover)....therefore the shaft does not need to be cut either.... (I know the 15 series motors are this way now)

-Kent

You are correct. That is why I was wanting the newer version.:thumbup1:

[britscoot]

I have the motor you seek in the swap shop.
http://forums.offshoreelectrics.com/showthread.php?t=22630


I have a Neu 1521 1.5d for sale with 5.5 connectors and 8mm shaft. Willing to trade for a 1527 1d or make me some offers. $200 shipped