Charging Connection?

[bettaman]

Hi,

Im new to this and have been doing a bit of searching around.

I have this charger. (http://rchobbies.com.au/store/product_info.php?products_id=60198)

I have these batteries (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=15368)

These are the leads from the esc (http://shop.rcboatbitz.com.au/index.php?main_page=product_info&cPath=30&products_id=407)

Now I assume the batteries will fit the lead above as they are both 5.5 bullet connectors.

The problem is i got the charger and the batteries and there doesnt seem to be a way of using the cables supplied to charge the batteries.

Do i need some sort of connector? i have read something about EC5 connectors but not sure if im off track.

[bettaman]

anyone?

[Make-a-Wake]

If the batts have 5.5's cut the end off the main banana plug charging harness and solder on 5.5's...............

[carlcisneros]

OSE here sells the 5.5mm bullet connectors needed to replace/modify the existing ends on the charging cable supplied with your charger.

[bettaman]

Thanks for that!

I got another issue though. The website says the batteries have 5.5mm bullet connectors. When I look at them they look really small.

Anyone own these batteries or know enough to tell me if they are actually 5.5mm because I think they may be even smaller than 4mm.

[Make-a-Wake]

Do you have the batteries? They come with 5.5s, measure yours to make sure, if they aren't then you got jipped on the bullets