djmaincheese
02-10-2011, 01:41 AM
I believe I have tried everything I can but I can't get my SeaKing 120A ESC to stop flashing RED and beeping every second.
I plug in the ESC while holding the throttle to the full position and I am able to program all the values..
Running Mode..
Cell Count..
Low Voltage Cut Off..
Timing..
I get to the end of programming and unplug the batteries to store my selection but when I go to plug them back in it just starts beeping again.
Anybody else have issues like this?
Should I get the programming card?
Any help would be greatly appreciated
I plug in the ESC while holding the throttle to the full position and I am able to program all the values..
Running Mode..
Cell Count..
Low Voltage Cut Off..
Timing..
I get to the end of programming and unplug the batteries to store my selection but when I go to plug them back in it just starts beeping again.
Anybody else have issues like this?
Should I get the programming card?
Any help would be greatly appreciated