View Full Version : hobbywing 80a hv esc how do you program it?
onegreenray
11-29-2010, 08:33 PM
ok noob questions, esc has two receiver wire one long one short, which do you use to program the esc? i have the hobby wing boat program card using an external 4aa battery pack to power the esc and program card i can't get the esc to program?
thx guys
JimClark
11-29-2010, 08:39 PM
what it didn't come with any documentation?
Make-a-Wake
11-29-2010, 08:41 PM
I have one...............the long wire goes to the reciever. I just programmed mine with my Radio based on the beeps. It took a bit to figure out since it works just a bit different than the 120a.
Jim, it actually doesnt tell you squat in the instructions.
britscoot
11-29-2010, 08:52 PM
connect the long wire to the program card first then connect power to the program card.
It might take a few seconds until the card lights up.
JimClark
11-29-2010, 08:52 PM
Just one of the reasons I prefer to buy form other sources
Hard to be sarcastic in a forum
Jim
I have one...............the long wire goes to the reciever. I just programmed mine with my Radio based on the beeps. It took a bit to figure out since it works just a bit different than the 120a.
Jim, it actually doesnt tell you squat in the instructions.
FighterCat57
11-29-2010, 09:31 PM
If you use the Programming card, make sure you use the marine faceplate. Otherwise the options won't match.
http://www.hobbywing.com/english/ArticleShow.asp?ArticleID=435
Programming:
http://www.hobbywing.com/english/ArticleShow.asp?ArticleID=453
onegreenray
11-29-2010, 09:59 PM
i read the half English instruction better and saw the note 4 in them, thank you for the replies guys.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.