View Full Version : Castle BEC
Anyone ever run a Castle BEC with the Hydra 240 HV ? The online directions show to dissconect the red wire on the ICE controllers but nothing about the HV Hydras. I know you need the red wire attached on the HV models. Just asking before i put one in. Thanks:smile:
BHChieftain
10-01-2010, 09:09 PM
Anyone ever run a Castle BEC with the Hydra 240 HV ? The online directions show to dissconect the red wire on the ICE controllers but nothing about the HV Hydras. I know you need the red wire attached on the HV models. Just asking before i put one in. Thanks:smile:
I run that config. I just cut the middle (red) wire on the Hydra reciever connector and wired in the bec onto the pos/neg battery lead hydra connectors.
See post #28 on my syncron build thread for some pics:
http://forums.offshoreelectrics.com/showthread.php?t=13793&highlight=syncron
Chief
ENCORE MAN
10-01-2010, 09:44 PM
I run that config. I just cut the middle (red) wire on the Hydra reciever connector and wired in the bec onto the pos/neg battery lead hydra connectors.
See post #28 on my syncron build thread for some pics:
http://forums.offshoreelectrics.com/showthread.php?t=13793&highlight=syncron
Chief
I never cut the red wire on an ESC. in case you decide to sell it at a later date. I use a servo extension and cut the red wire in the extension and your expensive ESC. is still intact. BG:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.