PDA

View Full Version : Etti datalogger RPM cable question



FE Wannabe
07-06-2010, 12:26 AM
I have the ETTI 150 amp datalogger that I use with my ETTI 150 Amp ESC, but I didn't get the RPM cable link with the logger.
I notice that the RPM connector on the ESC has 2 pins (Signal & gnd) and the RPM connector on the datalogger has 3 pins (Signal, +5V & gnd).
Does anyone have the cable to let me know what the pinouts are on it? I am just wondering if the +5V pin gets used or not? I plan on making my own cable.

Thanks guys,
Brad

FE Wannabe
07-09-2010, 03:23 PM
So, no one else out there has an ETTI datalogger with the RPM cable?

Anyone......Anyone......Bueller? :noidea:

I have tried to e-mail Dee at ETTI a couple of times, but I have not received any response as of yet.

If I don't hear any thing from anyone, I may just connect the Signal and the Ground connectors and not connect the +5V and see if I get a reading. I just don't want to fry something connecting it incorrectly.

Brad

FE Wannabe
07-10-2010, 04:07 PM
Dee responded to my second e-mail, the first didn't get through.

The answer for anyone else who cares is:

All that needs to be connected is the Signal and Ground wires, the +5V is not used, like I had assumed.

I made my own cable from a female to female receiver extension wire with the connector pins changed to match the datalogger and the ESC.

Brad

flortje
09-12-2013, 04:28 PM
hello
wath are the pinouts ?
greets