View Full Version : Connecting an Etti Capp Board
LarrysDrifter
06-10-2010, 07:59 PM
Does anyone know where to solder the wires on and Etti capp board?Is it the "foil"squares or the dots of solder on the bottom?
Steven Vaccaro
06-10-2010, 09:38 PM
http://www.offshoreelectrics.com/prodimages/etti-caps-3.jpg
Does anyone know where to solder the wires on and Etti capp board?Is it the "foil"squares or the dots of solder on the bottom?
Steven Vaccaro
06-10-2010, 09:41 PM
Use an exacto knife to remove about 1/4" of the insulation and then solder to the cap board.
LarrysDrifter
06-10-2010, 09:59 PM
Thank you very much.Looks like it gets soldered to the "square" part.Could I use 12AWG wire to make the connection instead of direct soldering?
Steven Vaccaro
06-11-2010, 07:40 AM
I'm told ideally its best to limit the length of wire used. Thats why its pictured inline.
Jeff Wohlt
06-11-2010, 10:44 AM
Larry, where in MO?
LarrysDrifter
06-11-2010, 07:41 PM
Larry, where in MO?
Festus.About 35 miles south of St.Louis.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.