Charger problem?

[Jeepers]

I have a Hyperion eos 610i, when I hook up my 7.4v packs to charge I get an error saying that my packs are over voltage, the balancer shows 4.5 volts on cell 1 and 4.9 on cell 2. My Fluke volt meter shows the total pack voltage below the 8.4v limit, individual cell voltage is around 3.7v, this is for one pack, but I get the same error on all of my other 16 packs, with the balancer saying the voltage is anywhere from 4.3 to 4.9 volts. I know the batteries are not charged as ran them at the last race and didn't have a problem charging last time. I have Neu Energy, Hyperion, PolyRc, and some Zippy Flightmax, all of them do this. what gives? anyone else have this problem?

Thanks
Sean

[m4a1usr]

Are you using an LBA10 balancer? Got another one you can switch it out with?

John

[Jeepers]

no I am using the chargers internal balancer.

[Jeepers]

nobody else has this problem??

[Raydee]

Have owned 6 Hyperion chargers and haven't seen that problem yet. There is a Rep on RC Groups, his username is NipponDave. Shoot him a PM and see what he thinks.

[Raydee]

http://www.rcgroups.com/forums/showthread.php?t=960657&page=159#post14995916
Loks like he has disabled PM's so just post in that forum and he will answer.

[Jeepers]

Thanks I will give him a message!