tiqueman
04-09-2010, 01:05 AM
I finally purchased a charger after over 20 years of RC-ing that has a cycle function. It came w/ great (what) instructions, but not so great (how) instructions.
If Im dealing w/ some older Nimh batts, If I set the charger to do say 3 cycles, discharge/ charge, what should my discharge settings be for say a 3000mah 6cell? I have an amp setting, then a volt setting then a charge setting.
So for example, it would look something like this
x.xA/ x.xV - > x.xA , being, discharge amps/ discharge volts - > charge amps
Is there a general rule of thumb when it comes to Amperage discharge per cell count or mah or something?
And same question but involving some Nicads I have layin around. What should A and V discharge rates be?
Oh and it is a Dynamite Passport Ultra charger
If Im dealing w/ some older Nimh batts, If I set the charger to do say 3 cycles, discharge/ charge, what should my discharge settings be for say a 3000mah 6cell? I have an amp setting, then a volt setting then a charge setting.
So for example, it would look something like this
x.xA/ x.xV - > x.xA , being, discharge amps/ discharge volts - > charge amps
Is there a general rule of thumb when it comes to Amperage discharge per cell count or mah or something?
And same question but involving some Nicads I have layin around. What should A and V discharge rates be?
Oh and it is a Dynamite Passport Ultra charger