WTB: 380 motor mount

[Diegoboy]

I'm in need of a 380 motor mount for my H&M Micro Kat (http://forums.offshoreelectrics.com/showthread.php?t=10649). One o those 380/540 mounts will be too wide for the tunnel. Please post what you are willing to part with.

Thanks!

[HOTWATER]

I'm in need of a 380 motor mount for my H&M Micro Kat (http://forums.offshoreelectrics.com/showthread.php?t=10649). One o those 380/540 mounts will be too wide for the tunnel. Please post what you are willing to part with.

Thanks!

Danny, I have two 380 mounts (for my Feigao 380 8L)...The orange one (2 3/4" wide measured w/screws in place) is an OSE one and the blue one is an ETTI (2 3/8" wide measured w/screws in place - mount can be fliped over to the flat side)...

Take your pick...Hope one of these will work for you...

-Kent

[Diegoboy]

Kent,
Thank you. How wide is the blue one without the screws & side plates?
How much would you like for the blue one?

Thanks again!

[HOTWATER]

Just the blue peice alone measures 1 7/8" wide...

If you can use it, you can have it...just pm me your address...

[Diegoboy]

Perfect!

Thank you! PM sent

[HOTWATER]

You got it...I will send it out to you...

-Kent

[HOTWATER]

Danny, your motor mount was sent out today...

-Kent

[Diegoboy]

Thank you Kent!!