View Full Version : WTB: 380 motor mount
Diegoboy
03-13-2010, 10:54 AM
I'm in need of a 380 motor mount for my H&M Micro Kat (http://forums.offshoreelectrics.com/showthread.php?t=10649). One o those 380/540 mounts will be too wide for the tunnel. Please post what you are willing to part with.
Thanks!
HOTWATER
03-13-2010, 04:19 PM
I'm in need of a 380 motor mount for my H&M Micro Kat (http://forums.offshoreelectrics.com/showthread.php?t=10649). One o those 380/540 mounts will be too wide for the tunnel. Please post what you are willing to part with.
Thanks!
Danny, I have two 380 mounts (for my Feigao 380 8L)...The orange one (2 3/4" wide measured w/screws in place) is an OSE one and the blue one is an ETTI (2 3/8" wide measured w/screws in place - mount can be fliped over to the flat side)...
Take your pick...Hope one of these will work for you...
-Kent
Diegoboy
03-14-2010, 01:58 AM
Kent,
Thank you. How wide is the blue one without the screws & side plates?
How much would you like for the blue one?
Thanks again!
HOTWATER
03-14-2010, 09:50 AM
Just the blue peice alone measures 1 7/8" wide...
If you can use it, you can have it...just pm me your address...
Diegoboy
03-14-2010, 11:37 AM
Perfect!
Thank you! PM sent
HOTWATER
03-14-2010, 01:26 PM
You got it...I will send it out to you...
-Kent
HOTWATER
03-14-2010, 04:39 PM
Danny, your motor mount was sent out today...
-Kent
Diegoboy
03-14-2010, 04:59 PM
Thank you Kent!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.