View Full Version : 60 size rigger for FE racing
carlcisneros
01-22-2010, 12:54 PM
I have a new 60 size rigger that I would like to run FE.
I do not know much at all about the motors and ESC's.
Any help would be greatly welcomed.
Thanks much
Carl
Steven Vaccaro
01-22-2010, 01:15 PM
Carl whats the size of a 60 rigger?
Also whats the tub depth. I've seen 90 size riggers where the tubs were not deep enough to enclose an electric motor. A cowl would have to be made.
carlcisneros
01-22-2010, 01:28 PM
it is aprox. 2 1/2 in deep.
It does have a cowl for it as well.
I would have to isolate the original motor section to make it water proof like the radio box.
Carl
carlcisneros
01-22-2010, 01:29 PM
it is aprox. 2 1/2 in deep.
It does have a cowl for it as well.
I would have to isolate the original motor section to make it water proof like the radio box.
The hull is 39 inches long.
Carl
jcald2000
01-22-2010, 05:55 PM
Nue 1527/1y with a Schultz 40-160XL controller 6s2P Hyperion 5000's and around a 1650 prop to start.
carlcisneros
01-22-2010, 07:24 PM
Thanks much
will check the online shop and see what the availablity is of the suggested units.
VERY MUCH APRECIATED :-)
Carl
Jeepers
01-23-2010, 01:12 AM
Nue 1527/1y with a Schultz 40-160XL controller 6s2P Hyperion 5000's and around a 1650 prop to start.
if there is enough room to fit that big schultz.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.