Your going to end up trimming that rudder a little. There is a lot of drag with a rudder that deep in the water but testing as is first and see what...
While I am waiting to get a good day to run the boat I went ahead and built a stand for the boat. I looked at a few ideas on the internet and came up...
Well, with the VESC we have the consultant guy who can help us. I'm sure for the hourly rate he's after, he'll at least be responsive (MGM are taking...
I use this on all my RX boards. I pop the RX case open, remove the electronics and paint the entire board with it. Its like a clear nail polish that...
Thanks I figured that was the issue. At least I learned to put silicon around the wire port. and thanks for the tip regarding preventing future water...
I have worked ? rewound a few hundred Leopards, some the X2 version but most are the older model. And holding the two stators in my hand at the same...