Activity Stream - Offshore Electrics Forums

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 08:37 AM

Raydee replied to a thread Updating Miss Geico Battery Placement in Fast Electric Rc Boating Talk

I came up with some 3D printed battery braces. If you are interested, I will post a link below. I use velcro to hold the batteries in place, and the...

4 replies | 140 view(s)

Today, 12:52 AM

TRUCKPULL replied to a thread Black Pearl II Hydro - 2020 in Boat Building Talk

Ray is this the one you are talking about on page #3? It is also shown under (16. Deck.) Larry

482 replies | 67301 view(s)

Yesterday, 11:02 PM

ray schrauwen replied to a thread Black Pearl II Hydro - 2020 in Boat Building Talk

Yes it is. I had just enough useful clamps to do the bottom. There are 2 parts not mentioned in the instructions and only one CAD image shows it....

482 replies | 67301 view(s)

Yesterday, 09:45 PM

Shooter replied to a thread Black Pearl II Hydro - 2020 in Boat Building Talk

The front part of the frame is the hardest part!

482 replies | 67301 view(s)

Yesterday, 09:13 PM

srislash replied to a thread Cheetah xl - hull problem?? in Fast Electric Rc Boating Talk

A set of Octura 447’s should be a good all around choice here. Low on the lift. This is my go to on my R42 cat which is similar in design, ( ie: wide...

24 replies | 760 view(s)

Yesterday, 06:26 PM

JimClark replied to a thread Wtb Miss K+ Kit in WTB "Wanted to Buy"

Ok I will take a look at what you have Sent from my motorola one 5G ace using Tapatalk

2 replies | 77 view(s)

Yesterday, 04:28 PM

Silver954 replied to a thread Cheetah xl - hull problem?? in Fast Electric Rc Boating Talk

Big cats handle like a drunk noodle at low speed. They have to be on top of the water going to act normal.

24 replies | 760 view(s)

Yesterday, 03:55 PM

MikeP323 replied to a thread Cheetah xl - hull problem?? in Fast Electric Rc Boating Talk

Thanks for your reply Notorious. Yes I have tried the struts at all reasonable angles. Now to lifting props. I have tried ABC three blades and...

24 replies | 760 view(s)

Yesterday, 10:07 AM

Marley-Buster replied to a thread New DoctorProps 644/3 NAMBA 3D Prop in * * * OSE Swap Shop Items for Sale * * *

Thanks for your interest. The prop did sell.

4 replies | 117 view(s)

Yesterday, 10:04 AM

photohoward1 replied to a thread Leopard x2 3660 4 pole with cooler in * * * OSE Swap Shop Items for Sale * * *

Sold on another forum. Sent from my iPhone using Tapatalk

3 replies | 198 view(s)

Yesterday, 09:49 AM

Jonathan DeMaria replied to a thread ----- TFL Mini Zonda 27" Hull ----- in * * * OSE Swap Shop Items for Sale * * *

Hello,still available

6 replies | 1434 view(s)

Yesterday, 08:21 AM

DougieDeeds replied to a thread Leopard x2 3660 4 pole with cooler in * * * OSE Swap Shop Items for Sale * * *

If the above scenario were to not play out, I?m happy to buy your motor Sir.

3 replies | 198 view(s)

Yesterday, 07:28 AM

longballlumber replied to a thread Wtb Miss K+ Kit in WTB "Wanted to Buy"

Jim I have an unfinished hull that is partially built. I can get you a picture sometime on Sunday. Thanks, Mike

2 replies | 77 view(s)

Yesterday, 04:54 AM

KiwiBoater started a thread 38 Inch RC Boat ripping in some saltwater in Show Off Your FE Boat - Videos

Heres one of my boats in some NZ Summer weather. Feel free to check out my YouTube channel and subscribe if you would like. ...

0 replies | 35 view(s)

Yesterday, 02:18 AM

Bp9145 replied to a thread Leopard x2 3660 4 pole with cooler in * * * OSE Swap Shop Items for Sale * * *

Will you take $40 shipped?

3 replies | 198 view(s)

Yesterday, 02:11 AM

Bp9145 replied to a thread New DoctorProps 644/3 NAMBA 3D Prop in * * * OSE Swap Shop Items for Sale * * *

Is this prop still available or has it been sold? Thank you

4 replies | 117 view(s)

Yesterday, 12:12 AM

Mark Scott replied to a thread Blazer Marine P Sport Hydro build in Boat Building Talk

Decided to take out the foam installed. Bought some 2 part foam, will be here next week. Will be going wire drive. That setup will be ordered on...

24 replies | 548 view(s)

01-27-2023, 10:08 PM

ray schrauwen replied to a thread Black Pearl II Hydro - 2020 in Boat Building Talk

I think mine was about 37mm high. I glued it up yesterday and it's now upside down to get the little bits glued in. Then comes the sticks etc... I...

482 replies | 67301 view(s)

01-27-2023, 08:55 PM

Shooter replied to a thread Black Pearl II Hydro - 2020 in Boat Building Talk

Hi Ray. I could give you the dimension the rear has to be raised. I'm planning on designing a jig for that eventually. I think I had a picture in...

482 replies | 67301 view(s)

01-27-2023, 08:51 PM

Shooter replied to a thread Blazer Marine P Sport Hydro build in Boat Building Talk

Looks great! A lot of detail on those sponson bottoms. Also like the tapered sides behind the air bleeds. We tried tapering the entire bleed at...

24 replies | 548 view(s)

01-27-2023, 05:49 PM

fweasel replied to a thread Updating Miss Geico Battery Placement in Fast Electric Rc Boating Talk

That's how I ran my Zelos. Helps get the weight forward when you're approaching triple digits.

4 replies | 140 view(s)

01-27-2023, 05:21 PM

Doonie replied to a thread G'day from Australia. in Fast Electric Rc Boating Talk

Thanks Fluid, that's exactly the information I am looking for. In answer to your questions I am a retired 74 year old with nothing left to prove....

2 replies | 80 view(s)

01-27-2023, 04:40 PM

Fluid replied to a thread G'day from Australia. in Fast Electric Rc Boating Talk

Welcome to OSE, that will be a really nice Cracker! What speed and run time are you wanting for your CBox? Will you be racing it? How often...

2 replies | 80 view(s)

01-27-2023, 02:00 PM

CJPB32 replied to a thread Sonic Wake for sale in * * * OSE Swap Shop Items for Sale * * *

Thanks for letting me know DD. I'm relieved to know it arrived safely. I hope you have fun with it!

17 replies | 721 view(s)

01-27-2023, 10:44 AM

T.S.Davis replied to a thread Cincinnati Model Boat Club in Rc Boating Club Directory

I have family in Grandville. My son has traveled to Grandville for multiple car races. He is the better driver between us. Under his senior...

10 replies | 128 view(s)

01-27-2023, 08:50 AM

DougieDeeds replied to a thread Sonic Wake for sale in * * * OSE Swap Shop Items for Sale * * *

Craig this thing is fantastic and arrived here in great shape, nice work on the packing job. Your work is meticulous on the boat, thank you again for...

17 replies | 721 view(s)

01-27-2023, 08:22 AM

Doonie started a thread G'day from Australia. in Fast Electric Rc Boating Talk

I'm building a 1280 mm Crackerbox and need advice as to what to power it with. Electric or ic? Plus any advice as to why you suggest whatever you...

2 replies | 80 view(s)

01-26-2023, 10:26 PM

Racingjake replied to a thread Updating Miss Geico Battery Placement in Fast Electric Rc Boating Talk

Thanks and nice setup, I really like the quad inlets and outlets too.

4 replies | 140 view(s)

01-26-2023, 10:26 PM

Mark Scott replied to a thread Cincinnati Model Boat Club in Rc Boating Club Directory

Guess I should have stated CMBC is a IMPBA affiliated club. We run nitro, gas and FE. Bring your fast boats, your slow boats.. If it's a RC boat,...

10 replies | 128 view(s)