Tweet
These were built by a friend of mine at work and he knows his stuff! I have no clue what the one rigger is but the other one is a Jae12. Jae is almost ready to run needs collars to hold the booms in place muffler servo and driveline and prop. Has fuel tank just not shown. Comes with dynamite .15 engine (condition unkown)
Needs a turn fin.
Length is just under 27" and about 14-1/8" at sponson width.
Jae12 SOLD SOLD SOLD Shipped in the US
Unknown rigger. Has room to run a Zippy 5000mah 3s battery. I would recommend smaller but thats what I ran in it. Needs painted in spots where it did not adhere. Front has a light bump which can be sanded out and easily painted. Needs servo,esc,.150 flex,prop motor.
Length is about 25" and is about 12.5" wide at full sponson width.
SOLD TO BASSTRONICS shipped in the US
Needs a turn fin.
Length is just under 27" and about 14-1/8" at sponson width.
Jae12 SOLD SOLD SOLD Shipped in the US
Unknown rigger. Has room to run a Zippy 5000mah 3s battery. I would recommend smaller but thats what I ran in it. Needs painted in spots where it did not adhere. Front has a light bump which can be sanded out and easily painted. Needs servo,esc,.150 flex,prop motor.
Length is about 25" and is about 12.5" wide at full sponson width.
SOLD TO BASSTRONICS shipped in the US
? WHAT RULES?
: 
Comment