Genesis maiden run

[tiqueman]

Id say this boat has tons of potential. Handles waaay better than I thought it would have.

This run is straight out of the box. Guessed on the adjustments, cog, etc. Needs very little fine tuning.

Run was on 3S2P 2650 mah. Ran about 4 minutes temps were low 120s on esc and motor and 111 on the batts. No gps this run, but Id guess just inside the 30s.

http://www.youtube.com/watch?v=boWyWrZoxmQ

Shot w/ my new Sandisc micro cam

[tomstoys2]

Nice video Scott! Pretty impressive for stock out of the box set up. I agree with you, seems to have some great potential.
Tom

[Tony]

Nice cat. Did you get it from HobbyKing site?

[tiqueman]

Nice cat. Did you get it from HobbyKing site?

Yes sir!

[FighterCat57]

Nice! That's the same "bouncing" that the Apparition did out of the box. Dropped the strut down and it went away.. Looks like it handles well and certainly has the appearance of an FE!
________
BUY BUBBLERS

[Rumdog]

It's probably the low speed causing the bouncing. The faster you go the more air in the tunnel, the more lift. That equals less bouncing. It is faster thatn what I thought it would be on 3s though!

[Brushless55]

Nice!
would 5000mah packs fit?

[tiqueman]

Nice! That's the same "bouncing" that the Apparition did out of the box. Dropped the strut down and it went away.. Looks like it handles well and certainly has the appearance of an FE!

Yeah thats what I figured I do as well. Drop it a bit. Right now its set, bottom of the strut at bottom of the sponson (set by table top)

It's probably the low speed causing the bouncing. The faster you go the more air in the tunnel, the more lift. That equals less bouncing. It is faster thatn what I thought it would be on 3s though!

Very true. And yes, it does better on 3S than I though it would as well.

Nice!
would 5000mah packs fit?

If I can get things wrapped up before dark, I will get a 3S2P 5800mah run in. Yes, 5000s' will fit with no problem. I ran my 2650s because they were charged.

[Brushless55]

I think the bottom of your strut should be 1/4" to 3/8" from bottom of sponsons
the prop needs to unload some

[tiqueman]

I think the bottom of your strut should be 1/4" to 3/8" from bottom of sponsons
the prop nees to unload some

That is the norm, however, with it lowered the bounce went away. And where it was, it was about 1/32 of an inch from being as high as it will go without mods. Also w/ its original placement, It cavitated A LOT.

[Brushless55]

but now I think is will load things up on the motor going below the sponsons

[tiqueman]

Yes it will. But the ride attitudes nice now. I will mess w/ it more tomorrow. Play w/ the cog and such. Then start changin props.